NORTH STATES 4936 Instrucciones página 7

If the gate does not stay closed, verify that the mark in the le upper corner of the gate is aligned with the mark on the
upper locking housing, as shown in Figure 12C.
If the mark on the le upper corner does not align with the mark on the upper locking housing, please make the
adjustments below to ensure that the door panel can be auto closed.
If the upper locking housing is offset toward the right (12A) or le (12 B), please loosen the screw on upper locking housing ,
then adjust the door panel and upper locking housing un the two marks are aligned (12C). Make certain to re hten the
screw (12D).
Figure12A
upper locking
left upper corner
housing
12C
If the upper locking housing is misaligned upward (12E) or downward (12F), please loosen the screw on the door lower
hinge (12G), then press the door panel and the door lower hinge together (12H) un the two marks on the le corner are
aligned. Make sure the screw is re htened.
12E upper locking
housing
Care
CLEANING:
Clean the Superyard using warm water and a mild detergent. Use a so cloth or sponge to avoid scratches. Never use
solvents or chemicals to clean the Superyard.
DISCLAIMER:
Any damage to property during installa
12B
door
left upper corner
panel
12D
12F
upper locking
housing
n of your safety gate is the sole responsibility of the end user.
Distributed exclusively in the United States by
North States Industries, Inc.
5455 Highway 169 N
Plymouth, MN 55442
www.northstatesind.com
Manufactured in
Guang Dong, China
upper locking
door
housing
panel
Note: Please use two
screwdrivers when
or loosening the screws (12D).
12G
door lower
hinge
Page7
tening
12H