The Front Panel - Alesis PROLINEAR DSP Manual De Inicio Rápido Para El Usuario

ProLinear DSP Quick Start Guide
Connecting and Starting the ProLinear DSP
1. Turn the rear panel Input Level control to the Minimum position.
2. Connect the power cable to the speaker.
3. Connect the audio source's output to the speaker with a TRS or XLR connector.
4. Turn on the audio source.
5. Turn on the ProLinear DSP.
6. After about five seconds, the front LCD panel will flash
7. The speaker will enter Program mode (see the Front Panel picture).
8. With the audio source material playing, gradually turn up the Input Level control until the speaker is
playing the audio material at a comfortable level.

The Front Panel

The ProLinear DSP front panel has a display and six buttons for operating the speaker.
The primary functions of the buttons are labeled in white. Edit mode functions (Value, Parameter and Band)
are labeled in blue.
(ENGLISH)
ProLinear DSP Rear Panel
PROGRAM / VALUE Up
PROGRAM / VALUE Down
dSP
, followed by the software version number.
VOLUME / PARAMETER Up
VOLUME / PARAMETER Down
PAGE
SAVE / BAND