HQ P.SUP.USB300 Manual De Instrucciones página 2

Charging your USB devices
1. Before using, check if the connected device's input voltage matches
with the 5V DC output voltage of the adapter. Make sure the
total loading does not exceed the rated output current of the DC
adaptor.
2. Choose the suitable connector and connecting USB cable. Connect
the USB cable with your digital device and the DC output of the
adaptor.
3. Plug the large end of the cord into the 12V car lighter power port
and the LED indicator will light on instantly.
4. Switch on your Digital device.
Specifi cations:
DC adaptor Input:
Output:
Fuse Replacement:
To check or replace fuse, simply rotate the plastic tip at the front end
of adaptor plug counterclockwise. Visually inspect the fuse element.
If it is blown or if you are unsure, replace the fuse (1AMP).
Important Safety Instructions
1. Do not short circuit the output terminals.
2. Do not try to use this car adaptor with appliance requiring more than
the rated power of the power adaptor.
3. Do not attempt to open this unit.
4. Remove from the car cigarette lighter socket when not in use.
5. Always turn off the digital device before you connect/ disconnect the
car adaptor.
6. Please start the car engine fi rst, then plug in the car adaptor.
12-24V DC
5V DC 1A
2