Flushing Kit; Principal Components; A/C System Flushing - FLO-DYNAMICS FK310 Manual De Instrucciones

Notice: Flushing an R12 A/C system with the FK310 and 134a is permissible only after the
R12 system has been recovered with a machine approved for R12 recovery and has been
under vacuum for at least 20 minutes.
Refer to Figure 1
:
a) Filter coupling
b) Coupling for Moisture indicator
c) Clip with check-valve (Inlet of System/Component)
d) Clip without check-valve (Outlet of System.Component)
e) Blue hose
f) Red tap (Liquid)
g) Blue tap (Vapor)
h) 5-liter bottle
CONNECTING THE FLUSH KIT TO THE CCST300/388
1) Connect the filter coupling (a) to the red tap (f) of the 5-liter bottle (h); [FIG.2]
2) Connect the moisture indicator coupling (b) to the blue tap (g) of the 5-liter bottle
(h). [FIG. 3]
3) Connect one end of the blue hose (e) to the filter coupling (a) and the other to the
Clip without check-valve (d). [FIG. 4]
4) Connect the low-pressure service hose of the R&R station to the low-pressure
coupling of the humidity indicator coupling (b) and the high-pressure service hose of
the R&R station to the high-pressure coupling of the clip with check-valve (c). [FIG.
5]
5) Open high- and low-pressure couplings. [FIG. 6].
6) Use the correct seat of the rotating disk for the section of the component to be
connected to the rubber cone. [FIG. 7]
7) Connect the rubber cone of the clip with check-valve (c) to the inlet of the
component to be flushed, and the clip without check-valve (d) to the outlet of the
component to be flushed. [FIG. 8]
8) Open the high- and low-pressure taps of the R&R station. [FIG. 9].
9) Invert 5-liter bottle (h) for best results. [FIG. 10]
When flushing an entire system, we recommend bypassing the accumulator/dryer and the
expansion device, TXV or Orifice Tube. If possible, use the inlet to the evaporator as washing
inlet and the outlet of the condenser as flushing outlet.
INSTRUCTIONS MANUAL

FLUSHING KIT

PRINCIPAL COMPONENTS

A/C System Flushing

-3-