Medico ELECTRONICS CCC405 Instrucciones Para El Uso página 69

CHARGING COMPLETED
Charger OFF
fault:
ERROR
ON
flashes
continuously
Battery OFF
fault: Group
flash with
ERROR
OFF
OFF
OFF
External OFF
error
source:
Group flash
with
ERROR
OFF
Figure 2: Signaling of faults
1) Always possible - charging will recommence once the mains voltage is OK.
2) During start-up.
3) During charging (- No standby charging in the event of a fault!)
4) Available capacity filled.
5) In the event of any interruption (fault!) to the charging process, the connection of an
incorrectly polarized battery or an attempt to charge batteries using an off-load voltage below
3V, ERROR will remain lit (steady) when connecting a charging plug.
6) ON: Light lit
Light status 6)
ERROR
OFF Prolonged flash
OFF Prolonged flash
OFF 2 flashes
ON 3 flashes
ON 4 flashes
ON 5 flashes
OFF 6 flashes
OFF ON
OFF: light not lit
Fault type
Mains voltage too low Contact electrician
Fault in charger
Battery fault:
Charging when
significantly depleted
not possible
Battery fault: Fault
during charging with
falling current -
battery defect
Battery fault: Main
charging time too
long. Battery defect
or charger too small
in relation to battery
capacity
Battery fault: Battery
voltage too high
Charger temperature
too high
No battery connected Standby mode
68
Designation
1)
Contact charger supplier
Contact battery supplier 3)
Contact battery
supplier 3)4)
Contact battery
supplier 3)4)
System fault 2)
Check that the charger is
positioned so that there is 5
cm of free space on all sides
5)
UK