Technical Service - Campbell Hausfeld PA210200AV Manual Del Usuario

Oil flow adjusting knob
Flow direction arrow
Figure 2 - detail showing location of flow direction
arrow and oil fill plug
unnecessary fittings, couplings, etc.,
that restrict airflow.
5. Connect the air supply to the inlet
port.
Operation
1. Before pressurizing system, make
certain the bowl is securely locked in
place by hand tightening bowl ring
until snug.
2. Fill the lubricator bowl with Campbell
Hausfeld Oil (ST127000AV) or clean,
non detergent SAE 10 oil.
3. The oil flow is controlled by the
narrow cylindrical adjustment
screw (See Figure 2). Turn counter-
clockwise for more or clockwise for
less oil delivery. The oil delivery rate
automatically adjusts with changes in
air flow.
4. The lubricator can be filled while the
system is under pressure. Slowly
remove the oil fill plug (See Figure 2)
Oil fill plug
www.campbellhausfeld.com
to allow relief of air pressure. After the
oil fill plug has been removed, pour
oil into the lubricator and then replace
it. Replace the oil fill plug before
resuming operation. Alternatively,
the bowl can be removed once the
oil fill plug is removed. If the bowl is
removed to replace the oil, be certain
the bowl is back in place and bowl
ring tight before replacing the oil fill
plug.
Maintenance
Release all pressure before
attempting to install, service,
relocate or perform any maintenance on
the air system. Personal injury and/or
property damage could occur.
removing the bowl. Personal injury and/
or property damage could occur. If bowl
is difficult to remove, it may be under
pressure.

technIcal seRvIce

For information regarding the operation or
repair of this product, please call 1-855-
504-5678.
PA210200AV
Always depressurize
the unit before
3