Loading Labels; Important - Newell Rubbermaid Dymo LabelWriter 450 Twin Turbo Guía Rápida De Inicio

4. Loading Labels

The LabelWriter Twin Turbo printer holds two label rolls, so you can print two types of labels without
having to change the label roll.

Important!

In order for the labels to feed properly during printing, pay attention to the following when loading
labels on the spool and into the printer:
• The label spool guide must be pushed flush against the label roll, with no gap. See Figure 6.
• The labels must be loaded with the left edge of the label inserted against the left edge of the
label feed slot. See Figure 8.
To load a label roll
Press the form-feed button to eject the labels that protected the
1
printer during shipment.
Open the top cover and remove any packing material inside the
2
label compartment.
Remove the label spool on the left from inside the top cover and pull
3
the spool guide from the spindle.
Hold the spool spindle in your left hand and place the label roll on the
4
spindle so that the labels feed from underneath and the left edge of the label roll is firmly
against the side of the spool. See Figure 5.
Spool Spool
spindle guide
Figure 5
5