Spectronics Spectroline EagleEye UV-A/White Light Manual Del Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USING THE LAMP MOUNT/SPRAYER
• To attach the lamp, pull back the metal clip at the top of the
sprayer, slide the lamp onto the mounting bracket and release
the clip.
• Remove the cap from the penetrant can. Place the jaws of the
sprayer above and behind the opening on the can. Squeeze
the tabs to attach the sprayer under the fi rst ridge on the can.
Do not touch the sprayer's lever until you are ready to spray.
• When the lamp mount/sprayer is attached to an aerosol can,
use both hands when shaking to mix contents.
REPLACING THE SPLASH GUARD
The EagleEye EE-365 lamp comes equipped with three splash guards that are also
available in replacement packs. They protect the LEDs from penetrant. In addition, one side
of the guard is fi tted with a particulate fi lter that protects the internal fan from foreign matter.
To replace, hold the lamp fi rmly in one hand and gently pull the splash guard from the top
with the fi ngers of the other hand. Align a new one with the indicators on top next to the
white LEDs and press into place.
Splash Guard
with Integral
Particulate Filter
REPLACING THE UV LENSES
• The UV lenses that cover the two UV-A LEDs must be replaced periodically, since they
will grow cloudy (solarize) over time from repeated use.
• Remove the splash guard and set it aside.
• Remove the four Phillips screws in the faceplate and retain them. Remove and set aside
the faceplate.
• Replace the solarized lenses with new ones. Reattach the faceplate with the four screws.
• Replace the splash guard.
UV-A Lens
Faceplate
5
Sprayer's Lever
Tab

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ek-3000

Tabla de contenido