La Crosse WS7014IT+ Manual De Instrucciones página 53

temperature transmitter" above).
2. Within 2 minutes of powering up the transmitter, insert the batteries in the weather station (see
"How to install and replace batteries in the weather station" above). Once the batteries are
in place, all segments of the LCD will light up briefly. Following the indoor temperature/humidity
and the time as 0:00 will be displayed. If this information is not displayed on the LCD after 60
seconds, remove the batteries and wait for at least 60 seconds before reinserting them. Once
the indoor data is displayed user may proceed to the next step.
3. After the batteries are inserted, the weather station will start receiving data signal from the
transmitter. The outdoor temperature data should then be displayed on the weather station. If
this does not happen after 2 minutes, the batteries will need to be removed from both units and
reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, the distance between the weather
station and the transmitter should not be more than 100 meters (see notes on "Positioning" and "868
MHz reception").
Note:
In the event of changing batteries of the units, ensure the batteries do not spring free from the contacts.
Always wait at least 1 minute after removing the batteries before reinserting, otherwise start up and
transmission problems may occur.
WHEN MORE THAN ONE TRANSMITTER IS USED
1. User shall remove all the batteries from the weather station and transmitters, and wait 60 seconds.
2. Insert the batteries in the first transmitter.
3. Within 2 minutes of powering up the first transmitter, insert the batteries in the weather Station. Once
the batteries are in place, all segments of the LCD will light up briefly. Following the indoor
temperature/humidity and the time as 0:00 will be displayed. If these information are not displayed on
the LCD after 60 seconds, remove the batteries from both units and wait for at least 60 seconds
before reinserting them.
29