Electrical Connections - Spectravision PLS600 Manual De Instrucciones

,0,123(819(:(2'$;<..<;%&'(=(%'$;#>?;%&'(@<'><.
Models Power Lumen *
PLS600 65W 1192 lm
PLS1200 100W 1788 lm
PLS2400 200W 3576 lm
* Specified at maximum 33°C water temperature
Completely water proof, IPx8 protection level
Thickness: only 21mm
Powered by separate power box PLX1200 over 4-wire 4 meter rubber cable
Bulb life of 30.000 hours
Installation:
Can be installed in any 1,5" water inlet
Precautions:
ALWAYS use with PLX1200 power box, NEVER with transformer
Maximum allowable water temperature: 33°C
Never to be used outside the water
Instructions and use:
The SPECTRAVISION light is a high technology electronic controlled light based on
white powerLED's creating a natural white color in the swimming pool.
The warranty of this product will be void when instructions for use and
installation are not followed correctly. No warranty when the lights are used
outside the water.

Electrical connections:

ATTENTION: reversing the polarity of the output power or
not following the color scheme of the wiring of the light,
can result in serious damage to the light and will void warranty.
!
(
# LED's Dimensions
16 12 cm ∅
24 21 cm ∅
48 21 cm ∅
Electrical connection of transformer to PLX1200 power box (Fig. 1):
The PLX1200 connects to the 26V power output of the power box.
Connect the RED wire to the +26V terminal and the BLACK wire to GND terminal.
The PLX1200 has two separate outputs for ADAGIO lights. Each of these outputs
can be connected to a PLS600 or a PLS1200 light (Fig. 1).
Each output has 4 different screw terminals to connect the ADAGIO light:
the RED wire of the ADAGIO light has to be connected to the R terminal
•
the GREEN wire of the ADAGIO light has to be connected to the G terminal
•
the BLUE wire of the ADAGIO light has to be connected to the B terminal
•
the BLACK wire of the ADAGIO light has to be connected to the COM terminal
•
Only one single PLS2400 can be connected to this power box (Fig 2). In this
case, the terminals of both outputs need to be connected in parallel:
<R with R> <G with G> <B with B> <COM with COM>
.
as indicated on the board Straps are included.
Always check the DIP switch settings (Fig. 3) BEFORE turning on the
power to avoid damaging the light and to void warranty.
Remote control PLXREM (Fig.4)
An optional remote control is available. It consist of two handheld controllers,
a radio module, an external antenna and 10 meter extension cable.
This module has to be plugged in the upper connector (see arrow).
The handheld controller has 4 buttons:
an ON/OFF button to turn the lights ON or OFF
the arrow buttons for scrolling through the different color programs (Table 1)
the WHITE button to select the desired choice of white
The antenna cable needs to be plugged into the RF connector on the module.
Install the antenna outside (the technical room) to improve signal reception.
Synchronizing two or more PLX1200 power boxes (Fig. 5)
Synchronization of multiple lights (or multiple power boxes) is obtained by connecting
the AB terminals between the different boxes: < A with A> and <B with B>
,0,123( 7!