Auta decor Serie Manual De Instrucciones página 5

auta
Audio's volume adjustment
´ The telephone interface disposes of volume adjustment in both ways of communication with the external panel. The
potentiometers do not actuate over the phone during a conversation with the phone station.
For its adjustment we should considerate 2 cases:
1.The interface is connected to a housing of a building that already has auta's door system.
In this case DO NOT MANIPULATE
conditions of the general installation.
The adjustment is made: establishing communication with the external panel, hanging up the phone handset & pressing the
key (#).
Once the communication is established we will firstly adjust the volume of the phone's receiver using the potentiometer P1
Coming up we will adjust the volume of the panel's loudspeaker using the potentiometer P2.
* Remark: The adjustment made with the potentiometer P1 affects to the adjustment of the potentiometer P2.
If we listen a very weak sound in the panel, we should reduce the adjustment value of P1 to could adjust an acceptable
volume through P2
2. Raw installation
We will firstly do the door system installation and will adjust the volume of the external panel, respect to the internal phones,
using the potentiometers of its speaker.
Once this adjustment made, we will proceed to adjust the volume respect to the phone station, as described before.
In the case of one single installation without auta's phones (only with interface), we could adjust the potentiometers of the
external panel just if during the adjustment of the telephone interface we do not get an adequate volume.
Characteristics
Supplying:
Consumption:
Receiver's volume adjustment:
Panel's adjustment:
Input calls detection through tones.
Phone line external panel switching:
Door opener release:
Plastic ABS box with 10 elements. Guide DIN or direct to the wall.
Installation
We should disconnect the door video door system's power supply before made the connexion.
The telephone interface will be supplied with 10 elements box. The fixation could be made either direct to the wall with the
screws supplied or over guide DIN.
The actual normative for phone installation should be respected when the installation's connexion was made.
The interface should be connected as nearest as possible from the phone wiring input at the housing. For its connection see
connection schedule together to this manual.
The interface should be connected to the telephone net for its correct functioning.
Connexion of a call extension
The equipment disposes of a terminal BELL that lets the connexion of a call extension somewhere far to the phone station. The
kind of bell should be adapted to the call system used in the door video door system as follows:
- For installation with TF-89 phones, we should use the buzzer bell 12 Vac - Ref. 730105
- For installations with TF-92, DECOR analogical PHONE or analogical DECOR MONITOR, we should use the electronic bell
Ref. 730106.
the volume potentiometer that is in the external panel due to it is adjusted to the
220 Vac
MA
(Potentiometer P1)
(Potentiometer P2)
key (#)
keys (*) (6)
4
TELEPHONE INTERFACE
Characteristics, installation.