habitat et jardin 91cm Instrucciones De Montaje página 16

14. From the inside of the Ladder Handle, insert the two Machine Screws through the Flat Washers, then
through the Ladder Handle and fasten in place using the two Lock Washers and Cap Nuts. (See Fig. 6).
15. Place the Ladder Base Plate under the plain ladder legs as shown in Figure 6.
16. From the top of the Plain Ladder Legs, insert he two Machine Screws through the Flat Washers then
through the Ladder Base Plate and fasten in place using the Hex Nuts (Figure 6).
17. Place the Swivel Leg Assembly over the Ladder Hinge and clip on the plain ladder legs with the swivel
ladder clamp button and the swivel ladder clamp as shown in Figure 6. Insert one plastic flat washers into
each recess between the ladder hinge and the straight ladder leg.
18. From the inside of the Ladder Hinge, insert the Machine Screws through the Plastic Flat Washer, then
through the Straight Ladder Leg and fasten in place using the Lock Washers and Cap Nut (See Fig. 6).
19. The Swivel Ladder Ass'y should be put outside the pool. Make sure the Ladder Latches are clipped on
the Ladder Clamps is in use. (See Fig. 7).
20. When the ladder is not in use, swing up the Swivel Ladder Assembly until the Swivel Ladder Clamps are
clipped on the Ladder Handle and hear with a 'click' sound. (See Fig.8).
21. To use the ladder, press the button of the Swivel Ladder Clamp with Button, and swing the ladder to the
use position as shown in the Figure 7.
- NOTE -
THIS STEP IS VERY IMPORTANT BECAUSE IT KEEPS THE HANDLES FROM SEPARATING FROM THE
LEGS. LADDER FAILURE WILL RESULT IF SCREWS ARE NOT PROPERLY INSTALLED!
- 16 -