WALMEC Asturomec 9011 HVLP Manual De Instrucciones página 18

MOD.
..................................................................
. . .
TECHNICAL SPECIFICATIONS
- Air fitting: G 1/4" M
- Product delivery fitting (version SP): G 1/4" M
- Maximum air pressure: 5 bar (73 psi)
- Maximum product pressure (SP version): 5 bar (73 psi)
Feed
Ø
Gravity
3.0
SP version
Gravity
4.0
SP version
Gravity
5.0
SP version
** Product flow was calculated with water, setting the recommended regulations.
. . .
U SE
Spray guns in the Novemila "GEL COAT" series have been designed for applying GEL COAT or dense products generally.
The instrument is not suitable for use with abrasives or products containing acids or petrol of any kind. To obtain the best
results, the following instructions must be followed carefully:
1. When possible, use an air pipe with a minimum internal section of ø 8 mm (0.3").
2. Make sure the compressed air used is perfectly filtered removing all water, oil or other impurities (for example, by installing
an Asturomec filter regulator ref. 61131 and Asturomec coalescent microfilter ref. 61201, or by the more complete and efficient
WALCOM TD PRO multifunctional filter and heating unit).
3
. . .
ADVICE FOR CORRECT USE
1. The distance between the spray gun and the surface to be painted must be set between 150 and 200 mm (5.9 - 7.9").
If the spray gun is working at too low a pressure and at too high a distance, it will not perform to the best of its capacity.
2. The jet from the spray gun must always be perpendicular to the surface being
painted and the paint must be applied in horizontal strokes.
Any eventual shift from this position when spraying will result in an uneven applica-
tion of the paint layer.
...
FORM OF THE FAN
- Air pressure too low
- Product viscosity too high
- Quantity of product too high
Adjust the air pressure, product quantity and spray aperture until
obtaining a regular imprint as in fig. C
9011 GEL COAT - 9010 sp GEAL COAT
Delivery **Product load
pressure
512 Gr/min.(18 oz/min.)
2.5-3.0 bar
676 Gr/min.(23.9 oz/min.)
(36-43 psi)
730 Gr/min.(25.8 oz/min.)
- Air pressure too high
- Product viscosity too low
- Quantity of product too low
18
. . .
ADJUSTMENTS
- Working pressure: 2.5-3.0- bar (36-43 psi)
- Fan: Fully open
- Air: Fully open
- Product: 2.5-3 turns
Fan dimensions
Air consumption
at 20 cm (7.9")
180-220 Lt./min (6.4-7.8 CFM)
180-240 Lt./min (6.4-8.5 CFM)
180-220 Lt./min (6.4-7.8 CFM)
180-240 Lt./min (6.4-8.5 CFM)
180-220 Lt./min (6.4-7.8 CFM)
180-240 Lt./min (6.4-8.5 CFM)
- Regular jet
18 cm (7.1")
20 cm (7.9")
24 cm (9.4")