Troubleshooting - iDance PARTY BALL 2 Manual De Instrucciones

Connecting Bluetooth
1. Press the STAND BY button to turn on BB10K. Hold the button to start connecting ( Blue indicator flash fast).
2. On your smartphone / Tablet, turn on Bluetooth and enable device scanning.
3. When BB10K shows on the Bluetooth scan, select it to connect it to your device.
4. When both devices are successfully connected (indicator LED turns ON), you are ready to play music
wirelessly from your device.
5. Press the PLAY button of external Bluetooth device to start music playback.
6. Press the NEXT / PREV (BLUETOOTH) of external Bluetooth device to switch between music tracks.
7. Hold the STAND BY button to reconnect other Bluetooth device.

Troubleshooting

If you have followed the instructions and are having difficulty operating the unit, locate the PROBLEM in the left
column below. Check the corresponding POSSIBLE CAUSE AND SOLUTION column to locate and fix the problem.
PROBLEM
Bluetooth cannot connect to BB10K
Intermittent Bluetooth music streaming •
No sound on selected source
SPECIFICATIONS
DC IN Power
Built-In Battery
SOUND SOURCE INPUT
Total Harmonic Distortion
Signal to Noise Ratio
Master Power Output
POSSIBLE CAUSE AND SOLUTION
• Make sure no other device from your friend or family is connected
to BB10K. When BB10K Bluetooth is connected, press BLUETOOTH
button would stay ON. So make sure BB10K indicating Bluetooth
is ready to connect. Also make sure your smartphone / tablet is
located close to BB10K less than 2 meters when pairing.
• Hold the BLUETOOTH button to reconnect again.
The wireless Bluetooth distance of BB10K is about 7-l0 meter in
open area. Below conditions could block you Bluetooth signal and
please ensure you would get rid of those:
• Metal protection on case for your phone/tablet
• Metal or wall is blocking in between your phone / tablet and
BB10K
• Another Bluetooth device is working close toBB10K
• Ensure that the BB10K is powered ON
• Check the ext. device volume.
• Check the volume level on paired Bluetooth device
• Battery power low / connection USB cable and charging power
again.
DC 5V , 800mA ( for battery charging)
3.7V , 1000 mAh
Bluetooth, 2x Mic in, Aux in,
<10%
Over 41dB
1.8W RMS
EN4