RCA MAF35BKR Instrucciones De Instalación página 2

Hardware Kit
(A) M6 x 60 Drywall Screw (x3)
(B) Concrete Anchor (x3)
(C) M4 x 12 Screw (x4)
(D) M4 x 20 Screw (x4)
(E) M6 x 12 Screw (x4)
Mounting the wall plate
Drywall Installation
Important! For safety reasons, this mount must be secured to a wood stud capable of supporting the
combined weight of the mount and display. Do not mount to drywall alone.
1.
Use a high quality stud fi nder to locate a stud where
you wish to install your mount. Mark both edges of
the stud to help identify the exact center.
NOTE: You must use the center of the stud
to avoid cracking or splitting the wood during
installation.
2.
Place the wall plate against the wall over the
marked stud. Make sure it is level or TV may not
hang straight when attached to wall bracket.
3.
Mark three locations for securing the mount to
the wall (see Fig. 1) and set the wall plate aside.
4.
Drill a 4.8 mm (3/16") pilot hole at each marked
location.
Concrete/Brick Installation
IMPORTANT! For safety reasons, the concrete wall must be capable of supporting the combined weight
of the mount and the display. The manufacturer takes no responsibility for failure caused by walls of
insuffi cient strength.
1.
Place the wall plate against the wall in the
desired location. Make sure it is level or TV
may not hang straight when attached to wall
bracket.
2.
Mark three locations
on the wall for
securing the mount
(see Fig. 3) and set
the wall plate aside.
3.
Drill an 8 mm (5/16")
hole at each marked
location. Remove any
excess dust from the
holes.
4.
Insert a Concrete Anchor (B) into each hole
so that it is fl ush with the concrete surface
(see Fig. 4). A hammer can be used to lightly
2 2
Fig.3
(F) M6 x 20 Screw (x4)
(G) M6 Washer (x4)
(H) Spacer (x4)
(I) S8 Allen Key (x1)
(J) 4.8 mm (3/16") Drill bit (x1)
5.
Place the wall plate back against the wall and
attach it using the drywall screws (A) provided
(see Fig. 2). Do not over-tighten these
screws. Ensure that the wall plate remains level
after all screws are secured.
Fig.1
tap the anchors into
place if necessary.
NOTE: If the concrete
wall is covered by
a layer of plaster or
drywall, the concrete
anchor must pass
completely through the
layer to rest fl ush with
the concrete surface.
5.
Place the wall plate
back against the wall and attach it using the
drywall screws (A) provided (see Fig. 2).
not over-tighten these
the wall plate remains level after all screws are
secured.
Fig.2
Fig.4
Do
screws. Ensure that