Thulos TH-KB12 Manual De Instrucciones página 13

OPERATION INSTRUCTION
1. Pull the unit outwards from the carton and place it on a solid hot-proof horizontal
surface.
2. Check if the accessories are complete, same as the accessories list.
3. Place the unit on a solid hot-proof horizontal surface. Take out the casters and
caster wrench to assemble.
Note: Casters with skid are for the two front holes and casters without skid
are for the two back holes at the bottom of the unit. (shown as fig.1)
4. Pull upwards the water tank and pull outwards about 10cm to the locking pin,
then add water. (shown as fig.2)
Note:
Water level must be between the MIN and MAX line. (shown as fig.3)
After some time operation, dust and dirt may occur in water tank. It is
recommended to change water and clean water tank frequently.
5. Only use the unit with correct AC outlet.
6. Insert the plug pin into a wall socket and turn on the power switch which is at the
side of the unit. A small beep sound can be heard and the power indicator will be
on.
Note:
To protect against electric shock, do not remove plug from wall outlet by wet
hand.
Unplug from outlet while moving the unit.
Insert the plug pin into the wall socket and make sure it is connected well.
7. Press "HUMIDIFIER" button to improve the air damp, avoid skin dry and spall in
winter.