Mounting Options - D-Link DWL-6700AP Guia De Instalacion

Unified Wireless Switch
DWL-6700AP
DWL-6700AP
Wireless Controller
• Manage the access point from the computer
via the Unified Wireless Switch or Wireless
Controller: Connect the access point to a
Unified Wireless Switch or Wireless Controller.
Connect your computer to the same network
as that of the Unified Wireless Switch or
Wireless Controller.

Mounting Options

Pole mount is the only option for the DWL-6700AP.
Cable Requirement
Use a Cat 5 cable with an even sheath.
The Ethernet ports on the DWL-6700AP access
point cannot accept a Cat 5 cable that has an
uneven sheath; the RJ-45 connector on the cable
will not fit properly into the receptacle on the access
point.
Warning: The DWL-6700AP is designed to receive
PoE power only from the proprietary PoE adapter
(24 V/1 A) included with the DWL-6700AP. The
DWL-6700AP is NOT an 802.3af-compliant device.
Connecting an access point to a Power over
Ethernet (PoE) device that is not approved by
D-Link can damage the equipment.
Pole Mounting Installation
Installation
1. Open the bottom panel with a Hex screwdriver
(T8).
6  D-Link DWL-6700AP Quick Install Guide
Computer
Computer
or
2. Plug the one end of Cat 5 cable into the
LAN1 or LAN2 port on DWL-6700AP, and the
other end to the port labeled POE on the PoE
Adapter.
3. Choose a gasket (6 mm or 4 mm) to fit the
Ethernet cable; if LAN2 is not in-use, please
take off the black gasket.
4. Close the bottom panel with a Hex screwdriver
(T8).