Orion Cobalt CO6004 Manual Del Usuario página 13

Symptom Probable Cause
Poor bass response
Crossover set incorrectly
Impedance load at amplifi er is
too low.
Battery fuse blowing
Short in power wire or incor-
rect wiring.
Fuse used is smaller than rec-
ommended.
Actual current exceeds fuse
rating.
Amplifi er fuse blowing
Fuse used is smaller than rec-
ommended.
Impedance load at amplifi er is
too low.
Speaker is blown with shorted
outputs
Actual current exceeds fuse
rating
12
Action To Take
Reset crossovers. Refer to the Internal Cross-
over Confi guration section of this manual for
detailed instructions.
Check speaker impedance load if below 2Ω,
rewire speakers to achieve higher impedance
.
Check power wires and ground connections
and repair or replace as needed.
Replace with proper fuse size.
Check speaker impedance load if below 2Ω,
rewire speakers to achieve higher impedance
.
Replace with proper fuse size.
Check speaker impedance load if below 2Ω,
rewire speakers to achieve higher impedance
.
Check system with known working speakers
and fi x or replace as needed.
Check speaker impedance load if below 2Ω,
rewire speakers to achieve higher impedance
.
© 2008 directed electronics—all rights reserved