ButterBall 23011114 Manual De Operación E Instrucciones De Seguridad página 4

2
1
Tabs
Step 1
Insert hinge on lid (2) into outer shell (1).
Lid will snap into place when assembled
correctly.
Note: To remove lid push tabs together on
outer shell, and pull lid up.
3
4
Step 4
Place basket (3) inside inner pot (4).
CALIFORNIA PROPOSITION 65
1. Combustion by-products produced when using this product contain chemicals known to
the State of California to cause cancer, birth defects, and other reproductive harm.
2. This product contains chemicals, including lead and lead compounds, known to the State
of California to cause cancer, birth defects or other reproductive harm.
3
ASSEMBLY INSTRUCTIONS
4
1
Step 2
Insert inner pot (4) into outer shell (1).
Insert inner pot at an angle to fit valve
into side opening of outer shell.
WARNING
Wash your hands after handling this product.
1
Mounting
Bracket
Step 3
Slide control panel and element (7)
down onto mounting bracket (shown in
Step 2) on side of outer shell (1).
Note: The control panel is correctly attached
when the heating element is positioned inside
the inner pot. Control panel must be correctly
attached for appliance to operate.
A built in safety switch on control panel will
prevent element from heating if not mounted
properly.
Step 5
Insert breakaway cord (10) into connection on
outer shell (1). Make sure "This Side Up" is
shown on top for proper connection.
Safety Switch
7
1
10