Super Ego SEH019500 Manual De Usuario página 16

1.4 Do not use the appliance if it has damaged or
worn seals. Do not use an appliance which is
leaking, damaged or which does not operate
properly.
Fig. 24
Fig. 26
DANGER
If there is a leak at connection turn OFF
the gas. DO NOT OPERATE THE GRILL. Contact the
Customer Service Representative in your area. If there
is a leak on your appliance (smell of gas), take it outside
immediately into a well ventilated flame free location
where the leak may be detected and stopped. If you
wish to check for leaks on your appliance, do it outside.
Do not try to detect leaks using a flame, use soapy
water.
When leak checks are complete, turn gas supply OFF
at the source and rinse connections with water.
DANGER
Do not use an open flame to check for gas leak. Be
sure there are no sparks or open flames in the area
while you check for leaks. Sparks or flames will result
in a fire or explosion which can cause serious bodily
injury or death, and damage to property.
PELIGRO
No almacenar cilindros de gas a BP de recambio
debajo o cerca del Grill. Si no se siguen fielmente
las instrucciones, puede ocurrir un incendio con
resultado de muerte o lesiones graves.
16
2. Check for gas leaks periodically: After a period
of nonuse you should perform the following
maintenance procedures for your safety.
2.1 Inspect the burner for correct flame pattern.
(Fig.15) Clean if necessary, following the
procedures outlined in the "Maintenance"
section of this manual.
2.2 Check all gas fittings for leaks.
You should check for gas leaks every time you
disconnect and reconnect a gas fitting. All factory-
Fig. 25
made connections have been thoroughly checked
for gas leaks. The burners have been flame tested.
As a safety precaution however, you should recheck
all fittings for leaks before using your Grill. Shipping
and handling may have loosened or damaged a gas
fitting.
Perform these leak checks even if your grill was
dealer or store assembled.
You will need soap and water solution and a rag
or brush to apply it. To perform leak checks make
sure the Burner is in the off position and turn on gas
supply.
Do not ignite burner while leak checking.
Check for leaks by wetting the connections with the
soap and water solution and watching for bubbles.
If bubbles form, or if a bubble grows, there is a leak.
NOTE: Since some leak test solutions, including soap
and water, may be slightly corrosive, all connections
should be rinsed with water after checking for leaks.
Cooking
Getting started:
Refer to "Operating Instructions" in this owner's
manual.
To light the grill:
Refer to the "Lighting Instructions" in this owner's
manual.
To Preheat the grill:
Light the Grill according the "Lighting Instructions"
in this owner's manual. Close the lid and turn the
Burner Control Knob to HI/START ( ) position.
Preheat the grill for 5-10 minutes (depending on
conditions such as air temperature and wind). Once
ENGLISH
DANGER
DANGER
DANGER