Publicidad
Idiomas disponibles
Idiomas disponibles
THESE INSTRUCTIONS SHOULD NOT BE FAXED OR REPRODUCED ON A DIGITAL COPIER. AMERICAN WOODMARK CORPORATION PROVIDES THESE INSTRUCTIONS ON AN "AS IS" BASIS AND DISCLAIMS ANY AND
ALL LIABILITY FOR ANY INACCURACIES, OMISSIONS OR TYPOGRAPHICAL ERRORS CAUSED BY ANY THIRD PARTY'S EQUIPMENT. When you use these instructions, you are consenting to be bound by the provisions
in this paragraph. These instructions provide an illustrative method for installing American Woodmark Corporation ("AWC") cabinets and/or accessories. AWC's instructions are not intended to address every possible
contingency that might be encountered during installation or to endorse the use of any particular tools. AWC HEREBY EXPRESSLY DISCLAIMS ALL LIABILITY FOR ANY CLAIMS FOR INJURY OR DEATH RELATED TO OR
BASED UPON THE USE OF THESE INSTALLATION INSTRUCTIONS AND ANY INSTALLATION INSTRUCTIONS OTHERWISE PROVIDED BY AWC.
Installation Instructions
Stem Glass Holder (SGH36U)
For Use With Wine Rack Cabinet (WRC), Wine Storage Cabinets (WSC), or Standard Wall Cabinets
This unit provides a storage system for
stem glasses under a wine rack cabinet,
a wine storage cabinet or wall cabinet.
Fits
This unit will fit under WRC wine rack
cabinets, WSC wine storage cabinets and
standard wall cabinets 36", 30", 24" and
18" wide.
Contents
• Stem Glass Holder Unit
• (8) #8 x 1" Pan Head Phillips Screws
Tools Needed
• Drill
• 1/8" Drill Bit
• #2 Phillips Screwdriver
• Saw (Hand)
• Pencil
• Tape Measure
• Safety Glasses
Procedure
TO MOUNT TO 36" WIDE WALL CABINETS:
Center Stem Glass Holder unit
1
under wall cabinet, making sure
mounting strips are against and
flush with the bottom panel and
behind front frame.
Using pre-drilled holes in
2
mounting strips (four per strip),
pilot drill 1/8" diameter holes
to a depth of 3/8" and fasten to
the bottom of the cabinet with
(8) #8 x 1" Phillips screws.
See Figure 1.
TO MOUNT TO 30" WIDE WALL CABINETS:
Place Stem Glass Holder unit on
1
flat surface with the mounting
strips facing up. Using the
screwdriver, remove the first two
rails and replace the first (smaller)
rail where the second rail was.
With pencil, mark each end of
both mounting strips. See Figure 2.
Cut each end of mounting strips
2
off, using marks as guides.
Center SGH36U unit under your
3
Wall Cabinet by using the two
horizontal mounting strips as
guides.
Using pre-drilled holes in mounting strips, pilot drill 1/8" diameter holes to a depth of
4
3/8" and fasten to the bottom of the cabinet with #8 x 1" Phillips screws.
See next page for mounting instructions to 24" wide and 18" wide wall cabinets
Read carefully before you begin installation
Figure 1
4-15/16"
Figure 2
1-1/16"
99883 5/08
Publicidad
