Troubleshooting; Cleaning & Maintenance - Alpina SF-7641 Instrucciones De Utilizacion

ENGLISH

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
Power failure or plug drop-off
V-belt drop-off
ABNORMAL NOISE Pulley loosen
OR VIBRATION Foreign object jumped pulsator
Fraction between pulsator & wash tub
Over tighten V-Belt
PULSATOR RUNS AT Loosen V-Belt / Motor fixing screws
LOW SPEED loosened
Warning:
VDE Plug
This appliance is equipped with a grounded, power supply cord. This is a safety feature. Do not attempt to defeat the
safety purpose of this plug.
BS Plug (optional)
If the product is fitted with a standard UK main outlet 3pin plug and the mains cable becomes damaged, it should be
replaced by a qualified electrician. If it is necessary to change the plug, the wiring instructions below must be followed at
all times. The fuse from the plug being replaced should be removed, as insertion into a mains supply socket would be
dangerous.
Mains plug wiring:
As the color of the wires in the mains cable may not correspond with the colored
markings identifying the terminals in the replacement plug, proceed as follows:
The wire colored BROWN or RED must be connected to the terminal that is marked
with the letter "L".
The wire colored BLUE or BLACK must be connected to the terminal that is marked
with the letter "N".
If the mains cable includes an earth wire, colored GREEN or GREEN & YELLOW, this
must be connected to the earth terminal, which is marked "E" or if the "EARTH"
cable does not contain an earth wire then on connection to the earth terminal is
required.
Mains Fuse
The replacement plug (BS 1363 type) must be supplied with a 13-amp fuse.
CLEANING & MAINTENANCE
1. Always unplugged the unit after use
2. Clean the barrel with water to get rid away the starch or bleach residue.
3. Wipe it with soft damped cloth.
4. Do not use any abrasive/harsh solutions that could lead the damage of the unit.
Level of Silk, wool
Solid Mode Light
Wash Timer
2-5
(min)
Rinse Timer
2-3
(min)
REPAIR/SOLUTION
Insert the plug well
Put on V-Belt properly
Tighten Pulley screw
Remove foreign object
Adjust the gap between the pulsator and the wash
tub
Adjust V-Belt properly
Tighten V-Belt properly or replace with a new screw
3
Cotton, Linen Cotton & Hemp
Light
5-10
3-5
Light
10-15
5-8