Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Self Charge Auto Jumper by Wagan Tech
Using the Self Charge Auto Jumper as a 12 Volt DC Power Source:
1. The Self Charge Auto Jumper comes equipped with a 12 Volt DC power
socket.
2. The socket of the Self Charge Auto Jumper has a positive (+) center pin.
Most, but not all, 12 Volt DC accessories come with this configuration.
3. Before connecting any 12 Volt DC accessory to the Self Charge Auto
Jumper, Check the polarity of the accessory (see accessory owners manual).
4. For DC accessories that do not have a positive (+) center pin, do not operate
at 12 volts, or have a different connector, you must use a DC-to-DC adopter
(sold separately).
5. The Self Charge Auto Jumper is designed to operate a number of DC
accessories successfully: 12 Volt radios, cellular phones, PDAs, etc.
6. A DC-to-DC adapter set is required to run these accessory items and is
available at most discount department stores.
Storage and Precautions:
•
The Self Charge Auto Jumper is NOT waterproof! It will be damaged if
submerged in water.
•
When not in use, the Self Charge Auto Jumper should only be stored in an
environment temperature of 32° F to 110° F.
•
During operation, the Self Charge Auto Jumper may become warm.
•
Discontinue operation if the Self Charge Auto Jumper becomes too hot.
•
Please be responsible: always recycle your Ni-Cd batteries!
4
www.wagan.com
Publicidad
Tabla de contenido
