Wagan Tech Brite-Nite 2741 Manual De Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Brite-Nite
Mega Spotlight
• Only use supplied chargers.
• Recharge fully every 3–6 months even if the unit is not in use. This will prolong the life
of the battery.
• This power unit is intended to be correctly orientated in a vertical or floor mount
position. Do not lay the spotlight lens downward when on.
• Do not use in wet conditions for the spotlight may short circuit.
• Do not expose to high temperature or fire, as the battery may explode.
• Charging produces hydrogen gas that may explode when exposed to fire.
• Do not use near flammable liquids, combustible materials or gasses.
• Do not use for any other purpose than momentary lighting.
• Do not modify or alter this unit.
• Do not charge the spotlight for more than 30 hours. Overcharging will shorten battery
life.
• Avoid charging the battery at temperatures below 4°C.
• The DC/DC Charger cigarette lighter plug becomes warm when used. Unplug from
cigarette lighter receptacle with caution.
• Keep out of reach of children.
CHARGING YOUR SPOTLIGHT
Your Mega Spotlight™ is supplied with two charging adapters. One adapter is powered by
standard 240 volts AC. This is the AC/DC charging Adapter. The other charging adapter is
the DC/DC charging adapter. Be sure to charge the unit completely before the first use. This
step will prolong the life of the internal battery. Use the AC/DC charging adapter for the first
charge. Charge the battery for 24 hour before first use. DO NOT use any charging means other
than those provided. DO NOT operate the spotlight while charging, as you may damage the
charging adapter and discharge the spotlight's batteries.
AC Charging
The AC/DC adapter provides a slow steady charge to the unit. Charge for a maximum of 16
hours (except for the initial 24 hour charge) and do not overcharge.
1. Make sure that all switches are set to "O", the off position
2. With the AC/DC Adapter, insert the DC plug into the AC charger jack on the spotlight
3. Plug the wall module of the AC/DC adaptor into the AC outlet on wall
4. The red indicator LED will light up to indicate the spotlight is charging
5. Indicator LEDs will illuminate increasingly, from RED, YELLOW to GREEN depending
on battery status at time of charging.
• RED LED: Battery is low
• RED/YELLOW LEDs: Battery is slightly full
• RED/YELLOW/GREEN LEDs: Battery is medium full
• RED/YELLOW/2 GREEN LEDs: Battery is completely full
3
by Wagan Tech
www.wagan.com
®

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Brite-nite mega spotlight2741

Tabla de contenido