Coupling Two Racks - Dell Energy Smart Guia De Instalacion

Coupling Two Racks

WARNING:
the size and weight of the rack cabinet doors, this procedure requires at least
two people.
WARNING:
the outer sides, after the interconnect kit is in place.
1 Unpack and set up both racks.
2 Unpack the coupling kit. See Figure 24.
The contents of the rack coupling kit include:
• One gasket strip
• Four coupling brackets
Figure 24. Rack Coupling Kit
1
1 gasket strip
WARNING:
in contact with the floor to form a seal around the bottom perimeter of the rack
enclosure. Removing the brushes may reduce the cooling efficiency within the
enclosure.
3 Remove the doors and side panels from both racks. See "Removing the
Front Door" on page 10, "Removing the Back Doors" on page 11, and
"Removing and Replacing the Side Panels" on page 13.
4 Cut and place a segment of the gasket strip, with its protective backing
removed, on one of the racks. The gasket strip must be placed along the
frame surface to be in contact with the adjacent rack. See Figure 25.
NOTE:
NOTE:
as long as they protect both racks from being scratched.
Never attempt to remove or install the rack doors by yourself. Due to
You must install the front stabilizer feet on the front of the racks and
All brushes supplied must be installed and the brush bristles must be
Ensure that the gasket strip is not installed on the extension.
It does not matter on which rack you place the gasket strip segments
2 coupling brackets (4)
Installation Guide
2
41