RIB RED Manual De Instrucciones página 19

POINT D
- CONNECTIONS
Carry out connection as explained in the figure.
POWER SUPPLY INPUT 12/24 VAC/DC
SELFTEST POWER SUPPLY INPUT
CONNECT TO THE SELFTEST
TERMINAL (if available) FROM THE
MAIN BOARD
S
ELF TEST INPUT CONNECTION
Connect the RADIO EDGE RECEIVER power supply inputs A*/D+ and
A/D- to the 12/24 Vac/dc power supply output from the gate/door main
control board.
Furthermore, in case of the main control board is RIB made with the safety
strip self-test output:
- position the RADIO EDGE RECEIVER JP1 jumper in according with the
chart below.
- connect the main board A/D+TEST to the input A/D+TEST of the RADIO
EDGE RECEIVER.
SELF-TEST-ENABLED RIB ELECTRONIC BOARD CHART
RIB ELECTRONIC BOARD
BOSS 24V - BOSS 24V CRX
BOSS 230V - BOSS 230V CRX
T2 - T2 CRX
T2 24V - T2 24V CRX
PT2 - PT2 CRX
PARK - PARK CRX
K 2007 - K 2007 CRX
K 2007 with 24V power feed accessory
K 2007 CRX with 24V power feed accessory
K2 24V - K2 24V CRX
PK2 24V - PK2 24V CRX
S1 - S1 CRX
J - J CRX
KS (with EXPANDER PLEX)
KS2 (with EXPANDER PLEX)
KS 24V (with EXPANDER PLEX)
KS 24V CRX (with EXPANDER PLEX)
CONNECT TO THE MAIN BOARD, IN SERIES TO STOP INPUT (if available) OR IN SERIES TO
SAFETY COMMON LINE
CONNECT A/D+ TEST TERMINAL
TO TERMINAL
Terminal 8
Terminal 8
D+ TEST
A+ TEST
D+ TEST
D+ TEST
D+ TEST
A+ TEST
A+ TEST
A+ TEST
A+ TEST
D+ TEST
Terminal 2 EXPANDER PLEX card
Terminal 2 EXPANDER PLEX card
Terminal 2 EXPANDER PLEX card
If the RADIO EDGE RECEIVER A/D+TEST input is unconnected, it'll be
automatically ignored.
Self-test consists of the RADIO EDGE RECEIVER functional test run at
the end of every gate/door opening.
The closing is allowed only if the system has passed the functional test.
If the receiver control gives negative outcome, the RIB electronic board
blocks the operator movement and the flashing light turns on, thus
signalling a state of alarm.
ENABLE SELF-TEST FUNCTION
THROUGH
DIP 6
DIP 6
DIP 13
DIP 12
DIP 13
DIP 9
DIP 10
DIP 10
JUMPER JP4
JUMPER JP4
DIP 12
DIP 7
Activated by inserting EXPANDER PLEX
Activated by inserting EXPANDER PLEX
Activated by inserting EXPANDER PLEX
CONNECT TO COM AND EDGE
INPUT OF THE MAIN BOARD
PLACE THE JP1 JUMPER
ON THE RADIO EDGE
RECEIVER IN POSITION
+/~
+/~
+/~
+/~
+/~
+/~
+/~
+/~
+/~
+/~
+/~
+/~
+/~
+/~
—
G
B