Audiolab Steel S7.4 Manual Del Usuario página 10

Circuit breaker: When amplifier overloaded (cause by the small load impedance of the
amplifier or the continuous input signal), the button of the circuit breaker will immediately
upspring, and will power off automatically to protect the amplifier. And you must exclude
overload condition, and then press the button of the circuit breaker, and the power amplifi-
er can resume to normal operation.
Channel mode switching switch:
Mainly complete the switching of STEREO mode and BRIDGE/PARALLEL by adjusting. Dial switch func-
tion: shown as M1 silkscreen, when M1 dial switch faces up which means CH1 is parallel to CH2, when
it faces down which means it is off. Key switch function: when key switch faces up which means CH1 is
bridge to CH2, when it faces down which means it is off.
Mode Switch:
MONO mode: make the two channel work independently, CH1 input signal by CH1 output, CH 2 input
by CH2 output. BRIDGE mode: make CH1 input signal from the BRIDGE output socket output, must use
the volume control of CH1 to adjust the volume PARALLEL mode: make CH1 input signal by CH1 and CH2
output socket output. The input socket of CH2 is no effect. Channel's volume can be adjusted inde-
pendently.
Sensitivity mode: It mainly adjusts the ratio between the input and output.
Speakon output connection (2CH)
Stereo connection
P. 10
AUDIOLAB STEEL SERIES -
English version