Auta 750944 Manual Del Usuario página 6

Functioning
keypad activation at standby
IN STANDBY, to prevent unwanted presses, the monitor incorporates a security system in which the touch keyboard
remains locked until the push button
calling and conversation
When a call is received from the entrance panel, the monitor starts ringing for a maximum of 30 seconds. As standard,
it performs 4 rings with intervals of 4 seconds between each of them.
During the call period the image appears on the screen, the user can open directly, pressing the button
a conversation pressing the button
the conversation, press the button
intercom calling
When the monitor is in standby, press 2 times the button
intercom menu will appear. In this menu we find a number next to each of the buttons on the right side. Pressing the
selected button will make a call to the intercom monitor that corresponds to that number.
Press the selection buttons
If we press on the "ALL" button we will make a call to all the available monitors.
edit intercom labels
When the monitor in standby, press 2 times the button
the intercom menu will appear. In this menu we will press the button
will allow us to change the intercom number assigned from the factory by a name of up to 6 characters (KITCHEN,
LIVING ROOM, etc ...)
To change the label, being in the "EDIT" mode, we will press
will select the label that we want to change
character, we will change it with the selection buttons
self-starting
By pressing the button
he wishes in the case of more than one is present in the installation.
With each press
opening of it by pressing the button
calling to concierge
If the monitor is in standby, by pressing the button
system does not have a concierge unit installed, the monitor will show the message "concierge not available" .
cctv surveillance function
The monitor allows the control of panels and CCTV cameras automatically. First we press the button
Each press activates a different device. To do this, each CCTV camera must be installed with an Auta digital
interface.
ding dong function
The monitor allows to replace the interior bell of the house, this integrates the two calls (outside panel and house bell)
in a single device. These calls will be differentiated with different melodies and flashes automatically. In order to have
this function, you only have to connect the button of the house bell to the monitor.
external functions
The monitor has 2 independent push-buttons
irrigation, etc ...
To do this, an Auta auxiliary relay must be connected to the control circuit we want to control.
Priority mode
By activating this mode the phone is able to end any conversation that is currently taking place in the system. Leaving
free the communication line.
is pressed twice quickly.
The conversation has a maximum of 90 seconds. If you want to continue with
and then
to change to the next group of monitors (15 available).
and then the user can establish communication with the PANEL / CCTV CAMERA that
the system will automatically switch to the next device, showing the image and allowing the
, when the AVANT logo appears press
, when the AVANT logo appears press
again, we will enter in the "EDIT" mode, which
again where we will enter in the "CHOOSE" mode. We
and then press . The cursor will begin to blink in the first
and validate with
and then , a call will be made to the concierge unit. If the
that allow auxiliary functions, such as garage doors, lights,
Bringing people together
EN
or establish
again, the
another time,
and then