Wiring Diagram - Ecco EC4204-SK Instrucciones De Instalación

Installation of other parts:
1. Find the appropriate place for camera mounting. e.g.: Drill a hole to install the flush mount camera.
2. Find an appropriate place in the cab to mount the monitor and speaker, or control box.
3. Control box should be placed in a clean and dry place.
Note: Monitor, speaker and control box are not designed to be weatherproof. Please keep these parts clean and dry.
Connection:
1. Please pay attention to the wire harness for connection between the proximity sensor kit and the back up system. Make sure that the
reverse trigger wire from monitor is connected to the reversing light.
2. Connect the 4 Pin Female plug to the monitor and 4 Pin Male plug to the camera.
3. The control box should be connected to the wire harness for VIDEO IN & VIDEO OUT. The sensor output cables should be connected
in sequence.
4. The control box and camera are both powered by the monitor which is powered by the vehicle battery through the DC Wire.
Note: Leave the output signal cable from sensors disconnected for testing.
5. Reference wiring diagram below.
Testing:
1. Switch the vehicle into reverse, reversing lights will turn on automatically.
2. Connect one output cable from sensor to the control box. The sensor will attempt to find an object standing within 1.5 meters to the
right/left or in front of the sensor.
3. Remove the sensor and connect others one by one for testing in the same way.
4. After testing is complete, connect all the sensors with the control box.
Notice: *Most problems that occur in the testing are usually caused by improper installation of the sensors.
Hints for Users:
1. This device is intended to offer assistance when reversing; however, safety while operating a vehicle is the responsibility of the driver.
Make sure to keep the vehicle at proper speed and pay attention to the surrounding conditions while reversing.
2. There may be improper reception, deviation and error in the reflected signal because of difference in material, angle or size of the
obstacle.
3. To turn on/off the voice warning for the system, the driver must have the vehicle turned off. Move the switch to the on/off position before
you power on the vehicle.
Speaker Switch
Camera Volume
Adjust
Main Harness
Audio Input
Video Output
Control Box
WHITE
BLACK
Sensors
BLUE
RED
Video Input

WIRING DIAGRAM

Camera
Speaker (optional)
Monitor
Page 3 of 5