Pfister Marielle LG532 Serie Manual Del Usuario página 3

1-HOLE INSTALLATION USING SINGLE POST
8
8C
8D
8E
8A
8 SINGLE POST RING INSTALLATION
Pass Single Post Ring (8A) over copper inlet / outlet tubes (8B), and press onto
Faucet Body (8C). Note: Tabs (8D) on Faucet Body (8C) must be aligned
with Grooves (8E) inside Single Post Ring (8A). To ensure this is the case,
rotate Single Post Ring (8A). When the tabs are aligned, the ring will not rotate.
9
9A
9 SINGLE POST BODY INSTALLATION
Retract Pullout Hose (9A) up through Faucet Body (9B), until the pullout hose
fitting is flush with the bottom of Mounting Shank (9C). Insert Faucet Supply
Tubes (9D) and Mounting Shank (9C) through the center hole of the sink.
Note: Do not feed the Pullout Hose (9A) back down through the spout yet.
8C
8B
8A
9B
9C
9D
ENGLISH
10
10G
10F
10D
10 MOUNTING HARDWARE INSTALLATION
From underneath sink, feed Washer (10A) and Mounting Nut (10B) over
Supply Tubes (10C) and Pullout Hose (10D). Thread Mounting Nut (10B) on
to Mounting Shank (10E). Hand tighten Mounting Nut (10B) to the underside
of the sink. Using either a Phillips screwdriver, or a slotted screwdriver, evenly
tighten the Mounting Nut Retaining Screws (10F), until faucet is firmly secured
to sink. From above sink, feed the pullout hose (10D) down through the spout,
until Hose End (10G) docks into the spout.
11
11 QUICK CONNECT & WEIGHT ATTACHMENT
Insert the end of the Pull-Out Hose (11A) into the Weight (11B). Screw Quick
Connector (11C) to the free end of Pull-Out Hose (11A).
3
10E
10D
10C
10F
10B
11A
10A
11C
11B