Continuous Drainage; Filter Removal - mundoclima MH-80-N Manual Usuario

CONTROL SWITCH
POSITION NO.
8
7
6
4
2
5. The operational temperature range for this unit
6. If the dehumidifier does not start (the operational light does not
illuminate) or the dehumidifier makes intermediate stop on unknown
reasons, please check the plug and power supply for poor connection. If
the plug and power supply are in normal condition, wait for 10 minutes
and restart the unit (because take about 10 minutes to reposition). If the
unit still does not starts in 10 minutes, please contact your local
distributor service station for repair.
7. When the dehumidifier is in operation, the running compressor will
produce heat and make the room temperature higher. This is normal
condition.
8．defrost light on is to indicate the operation of defrost is start. During this
operation mode, compressor will be switched off and air motor will be
turned on.
DRAINAGE INSTRUCTION
The extracted water can be collected by water tank, or drained continuously
with a PVC hose (not available):
APPROXIMATE
HUMIDITY SETTING
20﹪
30﹪
40﹪
60﹪
80﹪
°C
is 5-32 .
12
USE OF WATER TANK:
When the water full indicator illuminates, the tank is full, and the compressor
and the fan will stop operation, please empty
the water tank:
1. Remove the water tank as Fig 01. and
empty it.
2. Insert gently the water tank into the unit
reach to its original position.

CONTINUOUS DRAINAGE

1. When you want to use this function,
please Pull out the water tank, and plug
the discharge water pipe in "Water out
hole" (See Fig.02). replace the water tank
into the unit, then you can operate the unit.

Filter Removal

•The filter can be removed from its slot by gripping the filter handle and
sliding it out from the back of the appliance.
• Every 2 weeks, remove the filter and
clean it with warm water, below 40° C.
Allow it to dry naturally and then
replace.
Fig 01
Fig 02
13