Insignia IS-CM100751 Guia Del Usuario página 11

IS-CM100751_combined.fm Page 9 Tuesday, April 12, 2005 10:14 AM
IS-CM100751 19-inch Color Monitor
Icon Control
T.Pin Corner
B.Pin Corner
Rotation
Degauss
Status
Signal Level
Recall
Color Test
Using Self Diagnosis
If the monitor does not display, press any key and the Self Diagnosis screen
opens. Self Diagnosis checks the status of the monitor and determines
whether there is a valid signal.
NO SIGNAL
OUT OF RANGE
HF: 30-95 KHz
V: 50-160 Hz
PC DISPLAY SETTINGS
CORRECT?
Function
Adjust the pin corner top when the top sides of
the screen are bowed.
Adjust the pin corner bottom when the bottom
sides of the screen are bowed.
Adjust the rotation when the screen is tilted left
or right.
Keep the monitor free from unwanted
magnetism that can result in color impurity.
Display horizontal and vertical frequency and
polarity.
Change the signal voltage if images run on the
monitor. Video input signal voltage varies
between video cards. The factory default is
0.7 V.
Reset the screen to the factory settings.
Display an RGB color bar to determine if the
screen color is expressed normally.
The No Signal screen opens when the VGA
connector is not connected to a computer or when
the monitor is in DPMS mode.
The Out of Range screen opens when the applied
frequency is under or over the normal frequency
range.
Normal range
H: 30-95 KHz
V: 50-160 Hz
www.Insignia-Products.com 9