IMPORTANT:
Before starting to install the opener, read this entire instruction manual carefully.
SAFETY NOTICE
The MOTORLINE garage door opener described in this manual is designed for the automation of sectional overhead doors. Any other use is
considered improper and will void warranty
WARNING: you are carrying out operations on machine systems classified in the automatic gates and doors category and as such failure to
comply with the relevant safety rules may result in personal injury and/or property damage.
Only qualified technicians should install and give assistance to the equipment. The installer has the responsibility to adhere to safety standards.
Unqualified personnel or those who do not know the occupational health and safety standards applicable to automatic gates and doors
category must under no circumstances carry out installations or implement systems.
The person who installs or services the equipment without observing all the applicable safety standards will be held responsible for any
damage, injury, cost, expense or claim whatsoever suffered by any person as a result whether directly or indirectly from failure to install / assist
the system correctly.
DESCRIPTION
The MOTORLINE SP SHUTTLE 60/100 requires 230V AC 50Hz power input and has a 24V DC motor. When the door is in operation, movement
can be interrupted by activation of the safety inputs (manual pull cord, transmitter, wall button if fitted and photocells if fitted). An encoder sets
open and close positions, slows down the speed at the end of the course and diminishes the noise.
A 433.92MHz radio receiver is built into the circuit board and the Receiver is coded with the self-learning technique. As an alternative to the
built-in receiver, the unit will accept any of the range of plug-in radio receivers. The unit has been designed to provide maximum reliability,
safety and flexibility of use.
The auxiliary output for photocells and external receivers' power supply is able to provide up to 250mAh.