2: Operation; Front Display Panel - IBM UPS750TLV/ Manual De Instrucciones

Tabla de contenido

Publicidad

2: O
PERATION
I
D
NDICATOR
ESCRIPTION
Online
This LED illuminates when the uninterruptible power supply is supplying utility power to
the connected equipment. If not illuminated, the uninterruptible power supply is either not
turned on, or is supplying battery power. When blinking, the uninterruptible power supply
is running an internal self-test.
AVR Trim
This LED illuminates to indicate the uninterruptible power supply is compensating for a
high utility voltage.
AVR Boost
This LED illuminates to indicate the uninterruptible power supply is compensating for a
low utility voltage.
On Battery
This LED illuminates when the uninterruptible power supply is supplying battery power
to the connected equipment.
Overload
This LED illuminates and the uninterruptible power supply emits a sustained alarm tone
when the connected loads are drawing more than the uninterruptible power supply power
rating (see Troubleshooting).
Replace Battery/
Failure of a battery self-test causes the uninterruptible power supply to emit short beeps
Battery Disconnected
for one minute and this LED to illuminate (see Troubleshooting).
This LED also flashes and a short beep is emitted every two seconds to indicate when the
battery is disconnected (see Troubleshooting).
F
F
EATURE
UNCTION
Power On
Press this button to turn on the uninterruptible power supply. (Read on for additional ca-
pabilities.)
Power Off
Press this button to turn off the uninterruptible power supply.
Self-Test
Automatic: The uninterruptible power supply performs a self-test automatically when
turned on, and every two weeks thereafter (by default). During the self-test, the uninter-
ruptible power supply briefly operates the connected equipment on battery.
If the uninterruptible power supply fails the self-test, the replace battery LED illuminates
and immediately returns to online operation. The connected equipment is not affected by a
failed test. Allow the battery to recharge for 24 hours and perform another self-test. If it
fails, the battery must be replaced.
Manual: Press and hold the

Front Display Panel

button for a few seconds to initiate the self-test.
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ups750thvUps1000tlvUps1000thvUps1500tlvUps1500thv

Tabla de contenido