End Of Product Life; Troubleshooting - Cuda LED-3000 Manual Del Operador

9.2 LIMITED WARRANTY
Your LED-3000 light source carries a 3-year warranty from the date of shipment on
workmanship and all defects of material. Should your product prove to have such defects
within three years from the date of shipment from ST Technologies, we will repair or
replace the product or component part without charge. Should your LED-3000 light source
need servicing under this warranty, please contact ST Technologies for return
authorization documentation. You should carefully pack the unit in a sturdy carton and ship
it to the factory. Please include a note describing the defects, your name, telephone
number and a return address. Warranty does not cover equipment subject to misuse,
accidental damage, normal wear and tear or if transferred to a new owner without
authorization from ST Technologies.This warranty gives you specific legal rights and you
may also have other rights that vary from state to state.
POST WARRANTY REPAIRS: You may return your product(s) for repair, shipping prepaid to
the factory. Your product will be inspected and an estimate of repair charges will be submitted
to you for approval. Payment must be received before repairs are completed.

In the US:

Customer Service
10.

END OF PRODUCT LIFE

In accordance with the European Waste from Electrical and Electronic Equipment (WEEE)
directive, we encourage our customers to recycle this product whenever possible. Disposal
of this unit must be performed in accordance with the applicable local environmental
regulations.
In the US a list of recyclers in your area can be found at: http:/www.eiae.org/.
Please contact our Repair Department to issue a return authorization to return product to
manufacturer at the end of product life.
11.

TROUBLESHOOTING

Problem
Main switch power
indicator (refer to 4.1) is not
lit when switched on.
The power indicator is lit,
but lamp is still off.
®
LIT195 CUDA Surgical
(English)
877-814-2237 (toll free)
904-208-2291
Solution
Check that the AC power cord is properly connected.
Check the unit fuses. If necessary, replace.
Press Stand-by switch to turn on the LED.
Increase the LED intensity.
Rev. B
Date of Revision: 08/05/15
Page 12 of 69