Zagg Power Amp 12 Manual De Instrucciones página 2

INTRODUCTION
With your new Power Amp 12, you'll never have to miss out again because of a
dead battery. Just read and follow these instructions, keep your Power Amp 12 by
your side on all your adventures, and never let your battery die again.
2 USB Ports
LED Flashlight
Micro USB charging port
CHARGING YOUR DEVICES
Your Power Amp 12 carries enough power to charge your phone up to four times*.
Plus, it features two charging outlets that allow for pass-through charging, so you can
charge two devices at once — even with your Power Amp plugged in! To keep your
devices charged:
1. Connect the USB end of your charging cable to the outlet on the
Power Amp 12.
2. Connect the other end of your charging cable to the device you want to
charge — the Power Amp 12 will automatically begin charging it.
3. Continue on your activity until your device is charged to your liking and
then disconnect the charging cable.
4. Recharge your Power Amp 12.
*Up to four charges based on a 1800mAh battery.
CHARGING YOUR POWER AMP 12
Your Power Amp 12 comes charged and ready to go; but here's how to recharge it
when you need to:
1. Connect the included micro USB charging cable to the micro USB
port on your Power Amp 12.
2. Connect the USB end of the included cable to your preferred 5V USB
outlet. Note: Do not leave your Power Amp 12 plugged into a wall
charger for extended periods of time. Doing so will diminish its
long-term performance.
3. The LED under the USB outlets will light and flash according to its
current battery level. This indicates your Power Amp 12 is charging.
4. Wait for the battery indicator lights to turn off, indicating your Power
Amp 12 is fully charged.
5. Disconnect the charging cable and enjoy 12000mAh of simple,
portable power.