Cleaning The Blender; Important Safety Instructions - Sammic TB-2000 Manual De Instrucciones

OPERATING INSTRUCTIONS
1. Make sure the blender ON/OFF switch
is at the OFF position
2. Insert power plug into an electric outlet
3. Place container assembly onto motor
base, ensuring that it is properly seated
on container cushion
4. Place lid on container and always hold
the container at start and during
operation
5. Adjust the speed for blending different
hardness of food using the variable-
speed micro switch
6. To operate at the maximal speed, press
and hold the pulse switch for quick
operation
7. Always place some liquid into container
when crushing ice cubes
8. Never operate the blender while the
container is empty and do not attempt
to remove or replace the container
while the motor is running
9. Never run motor while container is not
in place
10. As the blender is a high speed unit,
blending times are greatly reduced in
comparison with normal blenders.

CLEANING THE BLENDER

1. Place a little warm water with detergent
into container. Place the lid on and
switch the blender
approximately 10 seconds.
container, rinse and leave upturned on
a bench to dry.
(The power is very strong, so most of
the residual food can be easily removed
by just using warm
detergent).
Do not clean inside of container by
hand unless cutting unit has been
removed.
2. To clean motor base use a slightly
damp cloth only. Never immerse motor
base in water.

IMPORTANT SAFETY INSTRUCTIONS

· Read these instructions carefully before
using the blender. Ensure that all other
operators have read and understand all
safety and operating instructions.
· Only user the blender on a flat, stable
and dry surface.
· Ensure that the blender is not operated
by children.
· Always ensure that the container is
properly seated in position and the
container lid (complete) is properly fitted
and secured
blender on. Place hand on top of lid
when starting the machine and during
operation.
· Take care when blending hot liquids, do
not fill container, the maximum quantity
is to the 1 litre mark. Always start motor
on lowest speed setting and increase if
necessary. Ensure that the lid is located
under raised projections on containers
before switching on. The lid can only be
removed when the blender is switched
off and the cutting unit has ceased
turning.
· Never place your hands in container
when it is fitted on the motor base. At all
times remember that the blender cutting
blades are very sharp and be cautious
when placing
container.
on for · Never leave the blender unattended
Empty when in use.
· Never immerse the motor base cord or
plug in liquid.
· Never insert the mixing rod directly into
the container without placing lid when
water and switching on the blender. To use the
mixing rod, remove lid insert and
replace it with the mixing rod. Never
insert any other object into the container
while in use.
TROUBLESHOOTING
The blender is fitted with a safety
overload switch ant the rear of the
machine. If the motor is overload, the
power will be cut automatically to ensure
safety. Please check and remove the
unsuitable blending goods, then press the
reset button (on back) to start again.
Checked the power cord is attached
correctly to the blender.
If your blender is still not functioning
correctly, please contact your dealer or
Sammic official technical service. Do not
attempt to open and repair the blender by
yourselves.
If the supply cord is damaged, it must be
before switching the replaced by service agents in order to
avoid a hazard.
ingredients into the
SPECIFICATIONS
F
(r.p.m.)
IXED SPEED
E
220-240V / 50-60Hz / 1
NERGY SUPPLY
L
OADING
D
IMENSIONS
- Width
- Depth
- Height
N
ET WEIGHT
ENGLISH
TB-2000
38.000
~
950 W
205 mm
230 mm
510 mm
5.5 Kg
3