Sea gull lighting Hunnington Guia De Inicio Rapido página 2

Install the Fixture
1A
If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate.
1
2
Secure the mounting plate to the junction box.
Screw the screw collar tightly onto the threaded nipple.
3
Determine the wanted height of the fixture and remove a portion of the chain by opening a link and removing it from the
4
bottom.
5 Screw the fixture loop onto the fixture.
Install the canopy and the collar nut onto the chain (in that order), then install the open link onto the fixture loop and
6
secure it in place by closing the link.
7 Weave the cord through the chain, screw collar, canopy, threaded nipple, and out of the junction box. Trim the cord
leaving enough to make electrical connections.
8
Connect the fixture to a suitable ground in accordance to local electrical codes.
9 Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
10
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the ceiling, and secure it in place by screwing the
11
collar nut tightly onto the screw collar.
JUNCTION BOX
CANOPY
COLLAR NUT
10
9
THREADED NIPPLE
1
3 SCREW COLLAR
4
5
2 2
MOUNTING PLATE
CHAIN
FIXTURE LOOP
FIXTURE