Turn Product On; Turn Product Off - Chauvet Professional WEL 2.0 Guía De Referencia Rápida

WELL™ 2.0 QRG

Turn Product On

Turn Product Off

Tilt Angle
LEDs Angle
Password
·
Turn the battery storage switch on.
·
Push the On/Off switch on the top for more than three seconds (the
built-in red LED will illuminate solid).
·
When not connected to the battery charger, the power status LED
indicates the amount of remaining battery charge, as follows:
Green:
Yellow:
Red:
·
Push the On/Off switch on the top for more than three seconds.
·
If storing the product for more than seven days after recharging it, also
turn the battery storage switch off.
·
Place the product on a flat, sturdy surface.
·
Release the extensible foot by shifting the foot release lever.
·
Keep the lever shifted to adjust the angle and release the lever.
·
Do not allow the product to tilt further than 10º.
·
Use the screws on the product's front panel to adjust the angle of the
LED panels.
·
The screw on the left adjusts the rear LED panel.
·
The screw on the right adjusts the front LED panel.
After being prompted, enter the following password by pressing:
<UP>, <DOWN>, <UP>, <DOWN>, <ENTER>
This password cannot be changed and must be used whenever prompted.
>70% (100~70% charge)
>20% (69~21% charge)
Empty (20%~0 charge)
6
EN