Safety Information; Preparation Before Installation - HydroTools Swimline 71610 Manual De Instrucciones

SAFETY INFORMATION:

1． Sand filters are designed to work with water temperatures between 33.8°F and 113°F (1°C - 45°C).
The filter should never be operated outside of these temperatures or damage may occur.
2． The installation should be carried out in accordance with the safety requirements of the swimming
pool industry and the specific requirements for each application.
3． The user should make sure that the installation is carried out by qualified authorized persons and
that these persons have first carefully read the following instructions. Incorrectly installed equipment
may fail, causing severe injury or property damage.
4． The operating safety of the filter is only guaranteed if the installation and operation instructions are
correctly followed.
5． To reduce the risk of injury, do not permit children to use this product.
6． Chemical spills and fumes can weaken Swimming Pool/ Spa compnents. Corrosion can cause filters
and other equipment to fail, resulting in severe injury or property damage.
Do not store pool chemicals near your equipment.
7． Any modification of the filter or use of unauthorized parts will void your warranty. The supplier
assumes no liability for the damage and injuries caused by unauthorized replacement parts and
accessories.
8． In the event of defective operation or faulty compnents, contact the supplier or its nearest
authorized service agent
SAND FILTRATION WORKING PRINCIPLE:
Incoming water from the piping system is automatically directed by the Multiport Valve to the top of the
filter bed. As the water is pumped through the filter sand, dirt and debris are trapped by the filter bed,
and filtered out. The filtered water is returned from the bottom of the filter tank, through the Multiport
Valve and back through the piping system.

PREPARATION BEFORE INSTALLATION:

1． Position the filter as close to the Swimming Pool/ Spa as possible.
2． The filter should be placed on a level concrete slab, very firm ground, or equivalent. Ensure that the
ground will not give way or erode, thus preventing any strain to the attached plumbing.
3． Position the filter under consideration of the piping connections, so that it is convenient for
operating and servicing.
4． Ensure that the compliance label is facing the front to allow for easy identification of pertinent
information, in the event of service requirement.
HOW TO INSTALL THE FILTER TANK:
1． Put the filter tank on the base, turn right to lock in place. Position the outlet drain plug facing
outward for ease of access.
2． Before filling the filter media into the filter vessel, do a visual check of the laterals.
Replace broken or loose laterals if necessary. Install the laterals, alligning the raised point of the
laterals to the raised indicator point on the umbrella style lateral holder.
2