MrHeater 1046FL-23-700 Instrucciones De Montaje, Cuidado Y Uso página 6

OPERATING INSTRUCTIONS
Main Power Button:
This button supplies power to all the functions of the log set. The Main power button must be in
the ON position, either from the remote or controls on the log set for the functions to work.
Heater Control Button:
This button controls the heater ON/OFF and 5 temperature modes from Low to High. When the
heater is first turned on, it will come on at the lowest room temperature setting. The log set will
remember the last heat setting and in later use the heater will start at that setting, unless power
to the unit has been interrupted. Each time the Temperature button is pressed, the temperature
set point increases, allowing you to adjust the ambient temperature.
Temperature:
HIGH
85 ˚F
80 ˚F
75 ˚F
70 ˚F
Flame:
High
Medium
Low
Flame Control button:
This button controls the brightness of the flame effect with settings at High, Medium and Low.
When the log set is first turned on, the flame will come on at the highest setting. The log set will
remember the last flame setting used and in later use the flame brightness will start at that set-
ting, unless power to the unit has been interrupted. Each time the Flame button is pressed, the
flame brightness decreases. The only way to turn off the flame effect completely is to turn off the
Main Power button.
A
Body
D8
D7
D6
D5
D4
D3
D2
D1
6
B Remote Control
To use the remote
control, first remove
the plastic tab by
gently pullling it out
of remote control (B).