Marq FOG400LED Guia Del Usuario página 5

Operation
Fluid
We recommend using high-quality water-based fog fluid with Fog 400 LED. You can purchase this
from a local or online retailer.
Important:
•
Using non-water-based fluids with this product will void its warranty.
•
Do not use flammable liquids such as oil, gas, perfume, etc. with this product.
•
Do not ingest any of the fluids used in this product. If you do so accidentally, contact a medical
professional immediately. Rinse your eyes and skin thoroughly if they come into contact with the
fluid.
Setup
Additional Safety Notes:
•
Do not spray the fog directly toward people or into an open flame.
•
Keep Fog 400 LED at least 3 feet (1 meter) away from other objects, and keep it at least 10 feet
(3 meters) away from flammable materials. The nozzle becomes very hot during operation, and
the machinery requires good ventilation.
•
Never touch the nozzle during operation. It becomes very hot; touching it during operation could
result in burns or other injuries.
•
Use in well ventilated environment to prevent excessive concentration of vapor.
•
Do not use this product as a space heater or humidifier.
Any item not listed in
1. After unpacking the box, unscrew and remove the cap at the top of the tank.
2. Fill the tank with a water-based fog fluid (described above).
3. Screw the cap back onto the top of the tank so it is secure. Make sure the tube (that passes
through the cap) is inserted as far into the tank as possible.
4. Connect Fog 400 LED to a power outlet.
5. On the rear panel, set the Power Switch to the On position. Fog 400 LED will begin warming up.
Important: If the environment is significantly colder than the temperature of Fog 400 LED, you
may need to wait for it to adjust to the ambient temperature.
Introduction Box Contents is sold separately.
5