Antenna Installation - Albrecht AE 6491 CT Guía De Usuario

Radio cb
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Antenna Installation

To obtain the best performance from your CB radio is important to install a good quality
antenna.
• You should purchase a suitable mobile antenna designed for the 27MHz
frequency band.
• Connect the antenna to the rear antenna socket using a PL259 coaxial connector.
Where necessary, solder the connector carefully at the inner connector of the
coaxial cable and avoid any short circuit with one of the thin copper wires of the
outer coaxial shielding.
• To obtain maximum performance from the transceiver, mount the antenna in a
suitable position for good and free radiation from the metallic car surface.
• Standard mobile antennas need a good car body ground connection for best
efficiency. Most standard mobile antennas cannot work without car body ground
connection!
• Most CB antennas (except our "Gamma" series) need a fine tuning for best SWR.
• Special ground less antennas are obtainable for motor homes or trucks in cases
where the antenna position is made from plastic or fiberglass or where a
grounding is not possible. Such antennas do only work on fiberglass or plastic car
body structures and do not work immediately on metallic structures.
• Do not use any transmit function (e.g. PTT) before installing the antenna.
Antenna SWR information
For radio communications, each antenna should have a good matching to avoid too
much energy loss across the transmission lines or defects of transmitter stages or
power amplifiers
A good antenna obtains an SWR (Standing Wave Ratio) of 1.5 or even better.
This means that most of the transmitting power is forwarded correctly from transmitter
via cable to the antenna, and that the amount of reflected power is small.
It is easy to measure the SWR, which is as well a good indicator for the correct
installation. An SWR meter is a basic and cheap test instrument, which should belong
to the toolbox of any installer and radio specialist.
High SWR values (more than SWR = 3.0 ) not only may damage the transceiver but
also lead to interference problems with other electronic items.
English
25

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ae 6491Ae 6490 ct

Tabla de contenido