Installing The Device; Remote Control - Duux Stream DXHCF01 Manual De Usuario

Warning: Batteries contain materials that
are harmful to the environment and must be
removed from the device before disposal
and disposed properly.
• When the device is not in use, please turn off the
device by pushing the stand-by switch on the
base of the device or remove power plug. Do
not leave the device in stand-by mode for a long
period of time.
• Do not place the power cord under the item
or cover the power cord. Place the power cord
properly to prevent tripping over it.
• Place the device on a flat and secure surface
before using the product.
• Remove the power plug when the device is not
in use. Never pull the power cord to remove the
plug.
• Please ensure that this product does not run into
any obstructions.
• Do not put your fingers or other objects into the
air inlet and outlet when the fan is running.
• When the product is operating, do not put any
soft items such as hairs, window/door curtains on
the device that might get caught between the fan
blades.
• Stop using the device when the power cord or
plug is damaged, or the device is damaged after
being dropped.
• Do not use this device outdoors. The device is
only for household and indoor use.
Do not use this device near a window or expose
6
to direct sunlight.
• This device cannot be used without a base and
should always be placed horizontally.
• Do not use this device in a place where gasoline,
paint or other flammable materials are stored.
• Remove the power plug before cleaning, repairing
or moving the device.
• Remove the power plug when the device is not in
use.
• Please use this device according to the
instructions provided in this manual.
• Do not disassemble the device yourself. If the
repair is required, please return it to your point of
purchase or service center.
• Products should be kept clean and regularly
maintained.
• Do not use extension cords.

Installing the device

1 Unpack the device and remove the packing
materials from the device. Store the packing
materials for possible future transportation.
Insert the power plug into a wall outlet and
2
press the safety switch to | position. You will
hear a double confirmation beep.
Press the power button to switch on the device
3
and the LED touch bar will illuminate and
operate in cooling mode at low speed.
3. Functions
1 2 3 4 5 6
LED touch bar
Power
1
Change speed
2
Timer
3
Oscillation
4
Heating mode
5
Natural wind & night mode
6
Note: if the display has been inactive for 1
minute, the lights will be dimmed by 80%.
1 2
6
3
4
5

Remote control

Power
1
Change speed
2
Timer
3
Oscillation
4
Heating mode
5
Natural wind & night mode
6
7