Cleaning And Maintenance - Lidl Service Crivit HG03357A Instrucciones De Utilización Y De Seguridad

Recommendation: Pump the product up and
leave it alone for one day. Let a new product air
outside in fresh air for a couple of days.
Recommendation: Place the activity toy on a
level surface at least 2 m from any structure or
obstruction such as a fence, garage, house, over-
hanging branches, laundry lines or electrical wires.
Pumping up the product
CAUTION! Inflatable plastic products react sensi-
tively to the cold and hot. That is why you should
never use the product when the ambient temperature
falls to below 15 ° C and rises above 40 ° C.
Otherwise damage to the product may result.
Note: Basically, only an adult should be responsible
for pumping the pool up. Make sure that you do
not pump too much air into the product. On no ac-
count should you use a compressor. Stop the process
when resistance increases during pumping and the
seams start to stretch. Otherwise the material might
tear. Only use manual pumps and / or pumps specifi-
cally designed for use with inflatable plastic products.
R oll the product out first and then check for
holes, tears and other damage (see Fig. A).
Note: You will need a pump with conical ad-
apter (ø approx. 10.2 mm) for the air valve
to inflate the product. Use a pump with conical
adapter with a diameter of approx. 17.8 mm
for the valve opening
T ake the end cap
1
order to open it.
T ake the end cap
4
in order to open the valve
Pump the product up.
IMPORTANT! Keep in mind that air tempera-
ture and weather conditions can affect the air
pressure inside inflatable products. In cold
weather the product behaves as if it has less air
pressure in it because the air inside contracts.
Under these conditions you may have to add
air. In hot weather the air inside expands. Un-
der these conditions you may have to remove
air in order to avoid overfilling.
6
.
2
off the stopper in
3
off the valve opening
5
.
6
P lace the end cap
order to close it.
P lace the end cap
in order to close the valve
5
Deflating the product
P ull the stopper
3
order to open it.
P ull the end cap
4
in order to open the valve
Press the sides of the air valve
your thumb and index finger.
A llow the air to escape completely.
S lowly fold the product together (see Fig. A).
Note: Make sure that the product is completely
dry before folding it together.

Cleaning and Maintenance

O n no account should you use corrosive or
scouring detergents.
U se a slightly damp, lint-free cloth to clean the
product.
Change the water of paddling pools frequently
(particularly in hot weather) or when noticeably
contaminated.
Repairing the product
Note: Minor damage can be repaired by the
owner using the supplied repair kit. Have any major
damage carried out at a specialist repair shop.
F irst let all the air escape from of the product.
C ut the patch to suit the size of the hole.
7
Note: Ensure that the patch
the hole and overlaps the edges of the hole.
R ound off the sides of the patch
off the protective foil.
onto the stopper
1 3
onto the valve opening
4
.
6
off the valve opening
2
off the valve opening
.
6
together using
6
is larger than
7
and pull
7
GB/MT
in
in
5
19