Pack Contents; Installation And Use; Service And Support - PCTV DVB-S2 Stick 460e Guia De Inicio Rapido

Sample illustrations are to be found on the first page.
1. PCTV DVB-S2 Stick
2. Power Supply Unit Body and Plug
3. USB extension cable
4. Mini remote control with battery/batteries
5. PCTV installation disc with software and drivers
6. Quick Start Guide
* Please note: the pack contents may vary from that illustrated depending on the version of your
product.
I. Connect the Satellite Antenna (see Figure I)
Connect the satellite antenna to the antenna input of your PCTV DVB-S2 Stick.
II. Connect to a Power Source
Caution: for your own safety, use only the provided power supply unit.
Before the first use, insert the delivered power plug into the power supply unit body.
To do this, slide the top of the plug into the designated slot on the power supply unit body as shown
in Figure II.a. Now push the plug (see Figure II.b) until it clicks into place (see Figure II.c).
Use the provided power supply unit to connect the PCTV DVB-S2 Stick to a wall socket
(see Figure III).
Alternatively: If you have a satellite reception setup with multi-switch, that has a dedicated power
supply, it might be possible to operate the PCTV DVB-S2 Stick without the external power supply
unit. In this case, make sure the LED on the PCTV DVB-S2 Stick lits green. Otherwise, please
connect the power supply unit, as described above.
III. Connect to a Computer (see Figure IV)
Please connect the PCTV DVB-S2 Stick to a free USB 2.0 port on your computer.
Use the supplied USB extension cable if necessary or to avoid any mechanical damage.
IV. Install the Software
Should the "Add new software" dialog appear during installation, please close it again by clicking the
Cancel button.
Place the PCTV installation disc in the appropriate computer drive. The installation starts
automatically; please follow the instructions in the set-up program.
V. Use the Remote Control (see Figure V)
If you wish to operate the PCTV DVB-S2 Stick with the supplied remote control, please ensure that
the remote control is pointed directly at the PCTV DVB-S2 Stick housing.
VI. Additional Information
LED behavior of the PCTV DVB-S2 Stick:
Solid green – TV reception is active.
Solid red – not enough power. Connect the PCTV DVB-S2 Stick to a power source.
Blinking red – a short circuit was detected either in the cable or in the satellite receiving system.
Note: the detected short circuit does not affect the PCTV DVB-S2 Stick.
Change the plug of the power supply unit (see Figure VI)
If you need to change the plug for use in another region, proceed as follows:
To release the plug, pull the Open button downwards. The button is located on the power supply
unit, underneath the power plug. The plug pops out. Now insert the appropriate plug as described in
section II.
For different or spare plugs, please visit: http://webshop.pctvsystems.com.
If you require technical support, visit our website at http://www.pctvsystems.com/support.
PCTV Systems S.à r.l. hereby declares that this TV reception device conforms to the fundamental
requirements and other relevant regulations of guideline 2004/108/EEC.
CE and FCC conformity and identical construction declarations for this product can be accessed at
http://www.pctvsystems.com/compliance.

Pack Contents*

Installation and Use

Service and Support

CE / FCC Conformity
Specifications are subject to change without notice or obligation.