Using Your Blender; Important - Omega MeGo Manual

USING YOUR BLENDER

IMPORTANT: Make sure that the motor base is plugged in for use.
BLENDER WILL ONLY BLEND FOR 45 SECONDS AT TIME. AFTER BLENDING FOR 45 SECONDS,
IT WILL AUTOMATICALLY END THE BLENDING CYCLE.
DO NOT FILL PAST THE MAX FILL LINE.
NOTICE: The Auto Pressure Release valve is located at the top of both 27 oz and 32 oz containers and is
designed to release any built up pressure inside the container as it blends the ingredients of both hot or
cold recipes. Small droplets may appear in the container contents bubble as pressure builds up and as
the air is being released as it's blending.
1. Push the raised small bump on top of the valve on the container once to ensure it is fully seated inside.
It is very important that the valve is inserted fully. The flat ring on the bottom of the valve that sits inside
of the container should be positioned over the ribs that surround the hole on the inside of the container.
If the valve is not inserted fully or correctly the container will leak.
2. Place the motor base on a clean, dry, level surface such as a counter or table top.
3. Add ingredients to the cup.
4. Place the blade onto the cup and twist it on tightly until you have a good seal. (Fig. 1)
5. Turn the cup upside down and place it onto the motor base, aligning the tabs on the cup with the
motor base. Turn it clockwise, the unit is ready for use.(Fig. 2)
6. Press down on the top of the cup in short intervals to activate. (Fig. 3)
7. When you have reached your desired consistency, stop the appliance by removing your hand from the
cup. Wait for the motor to stop running. Then turn the cup counterclockwise (Fig. 4) and pull straight up
to remove. (Fig. 5)
8. If it is hard to remove the Blending Blade from the container after blending, push the valve to the side
once to release pressure inside the vessel. Remove blending blade.
NOTE: Do not overfill! To avoid spilling, do not add ingredients past the "Max" fill line.
8