Quick Setup; Top Panel Overview - Akai Professional RPM8 Guia De Inicio Rapido

BOX CONTENTS
RPM8 Speaker
Power cable

QUICK SETUP

1. Turn the rear panel INPUT LEVEL CONTROL KNOB to the Minimum position.
2. Connect the power cable to the speaker.
3. Connect the audio source's output to the speaker's XLR / 1/4" LINE INPUT with a 1/4" or XLR
connector.
4. Turn on the audio source.
5. Turn on the RPM8.
6. With the audio source material playing, gradually turn up the INPUT LEVEL CONTROL KNOB until the
speaker is playing the audio material at a comfortable level.

TOP PANEL OVERVIEW

1. POWER / CLIP LED – This LED will be green when the monitor is on. The LED will flash red if the
signal is clipping. If this happens, decrease the setting of the INPUT LEVEL CONTROL KNOB.
2. PRECISION-TUNED BASS PORT – Enhances the bass response of the monitor.
3. SILK DOME TWEETER – The monitor's high-frequency driver.
4. KEVLAR WOOFER – The monitor's low-frequency driver.
5. INPUT LEVEL CONTROL KNOB – Adjusts the strength of the signal being sent to the monitor. This
allows all types of audio sources to be used, from stand-alone CD players to professional mixers.
6. XLR / 1/4" LINE INPUT – Connect your audio source to this input using an XLR or 1/4" (TS or TRS)
cable.
7. POWER SWITCH – Turns the monitor on or off.
8. IEC POWER CONNECTOR – Provides power from a 100-230 V, 50-60 Hz AC power source.
Quickstart Guide
Safety Instructions & Warranty Information
1