Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Precautions
„ Improper tightening of the screws - (See figure 5) - may cause air to
leak into the unit and between the ceiling and the decoration panel
(1), resulting in formation of contamination (2) and dew (3).
„ If there is a gap remaining between the ceiling and the decoration
panel after tightening the screws, re-adjust the indoor unit body
height. The indoor unit must be kept leveled and the drain piping
kept unaffected.
2 Wiring of the decoration panel (See figure 6)
Make sure to turn off the power supply before wiring!
1 Screws (2)
2 Switch box
3 Swing flap motor lead wire
4 Swing flap motor lead wire fixed by tie wrap to the rest of the wires
(See detail in figure 6)
5 Connector of the indoor unit PCB (X105A)
6 Tie wrap
1 Remove the electric components box lid. Loosen 2 screws and
slide the electric components box lid in the direction of the
arrows.
2 Securely connect the connector of swing flap motor lead wire
installed on the decoration panel. Attach the swing flap motor
lead wire to the rest of the wires firmly by tie wrap (from indoor
unit accessory set). (See figure 6)
3 Replace the electric components box lid reversing the procedure
to remove it.
Make sure that the swing flap motor lead wire is not
caught between the indoor unit and the decoration
panel and inbetween the electric component box lid.
Installation of the suction grille to
decoration panel
Install the suction grille (See figure 7)
1 Decoration panel
2 Suction grille
3 Suction grille hinge (attached to decoration panel)
1 Remove the transportation tape which is securing 2 suction grille
hinges in place.
2 Attach the suction grille to hinges by pressing the hinge and
inserting both ends of hinge to holes on the suction grille.
(See figure 7)
3 Make sure that the suction grille is attached to the decoration panel
properly by 2 hinges.
4 Close the suction grille by reversing the procedure shown in
"Preparing the decoration panel for installation" on page 1.
„ The suction grille may be installed in 4 directions by simply turning it
90 degrees.
„ Change the direction when adjusting the direction of the suction
grille of multiple units or to comply with the demands of the
customer.
2
English
Publicidad
Tabla de contenido
