Tabla de contenido
Publicidad
A
SAFETY
EN
READ AND SAVE THESE INSTRUCTIONS
•
Important Safety Instructions
WARNING – To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid-
State Speed Control Devise
•
Installation Instructions
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
•
Installation work and electrical wiring must be done by qualified person(s) in accordance with
applicable codes and standards, including fire-rated construction.
•
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
•
Use this unit only in the manner intended by the manufacturer. If you have questions, contact
to the manufacturer.
•
Before servicing or cleaning unit, switch power off at service panel and lock the service
disconnecting means to prevent power from being switched on accidentally. When service
disconnecting means cannot be locked, securely fasten a prominent warning device, such as a
tag to the service panel.
! WARNING: MANUALS
This product has been designed to operate safely and reliable for several years. However because
of its electronic nature manuals and technical information supplied along with the hand dryer
must be carefully read. Please keep this manual and the rest of information for future consults.
If you transfer the unit to a third party please include manuals and unit technical information.
!! WARNING: ELECTRICAL CIRCUIT:
This unit must be powered by a dedicated circuit branch protected by a circuit breaker with the
appropriate rating:
Model 240V:
Circuit Breaker: 16A
Model 120V:
Circuit Breaker: 20A
Circuit cable must fit current consumption for your product as stated in this manual.
SAFETY AND USE
•
This unit has been designed for indoor use only, covered from water sun and extreme
temperatures do not use it outdoors or close to moisture and heat generators.
•
Minimal distance to water source must be at least 16 inches (40cm).
•
Must be installed following the instructions of this manual.
•
Manufacturer is not responsible for damages caused by misuses or defective installations
•
This hand dryer can only be revised maintained and repaired by trained and authorized
personnel.
•
Always use original pieces and spare parts.
•
Power the hand dryer from appropriate power source according to the acquired equipment.
The unit electrical specifications plate shows the power rating.
•
Children must be supervised by an adult while using this product.
•
This product is designed for an efficient and quick hand drying. Never try to dry any other part
of the body
•
Foreign objects must not be put neither in nor over the hand dryer
•
Heavy objects must not be put over the hand dryer
•
If this unit fails it must be taken out of order and technical service (or distributor) must be
called for a product check.
•
Inner space of this product is protected and locked by screws so only trained and authorized per-
sonnel should revise this unit. There are neither serviceable nor replaceable parts inside the unit.
4
2
SEGURIDAD
SÛRETÉ
SEGURANÇA
DISPOSAL
MAINTENANCE
•
External: This unit must be cleaned once per day using a soft cloth with water for removing
dust and water over external case. Do not use scouring agents or all purpose cleaners. Never
immerse unit in water.
•
Water Tank: Water from drying process is recollected in a tank located in bottom part of the
unit. Water tank must be emptied at least once per week. This unit generates a visual and
audible alarm when tank is near high level. If tank is not emptied water will overflow dropping
to the floor. This unit works properly even when high level alarm is in ON status.
•
Dust Filters: This unit has 2 dust filters (one per motor) located in water tank. This filters need
to be revised and cleaned at least once per week. Please consult maintenance section of this
manual before performing any maintenance operation.
INSTALLATION AND OPERATION
Revise related sections of this manual
TABLE OF SPECIFICATIONS
MODEL:
Voltage
Frequency
Power
Current
Electrical Isolation
Air Speed
Drying Time
Dimensions
Weight
Protection Level
This unit complies with the recognised regulations of technology and relevant safety directives.
We hereby confirm the conformity with following European directives: 89/336/EEC (92/31EEC)
y 73/23EEC (93/68/EEC).
Subject to modifications without notice.
Packaging:
Packaging protects the unit in warehouse and transportation. It is made of
recyclable materials. When packaging is no longer needed, dispose it
appropriately according to recycling normative.
When replacing a product:
This unit has been marked with European WEEE symbol. Obsolete or inoperative
units must be disposed according to electric and electronic waste management
normative in your country. This unit must be disposed in an appropriate
manner to avoid potential environmental damages or just for re-cycling some
of their materials. In Europe you must dispose this unit in a recycling centre
in your area or contacting your dealer or local government.
XAP1760AL
240V
220/230/240V~
50/60 Hz
1.760 W
8.0A @ 230Vac
Class ll
125 Mph (200 Km/h)
10-15 s
11.81x7.67x24.29 (inches)
300x195x617 (mm)
21.1 Lb (9.55 Kg)
IP33
XAP1762AL
120V
110/120V~
50/60 Hz
1.749 W
15.9A @ 120Vac
Class ll
125 Mph (200 Km/h)
10-15 s
11.81x7.67x24.29 (inches)
300x195x617 (mm)
21.1 Lb (9.55 Kg)
IP33
Publicidad
Tabla de contenido
